Path: Home » products » Time products » gle/GPS-IRIG-ENC-100-OEM


Main features
 Compact construction

 Embedded 72 Channels GPS L1, GLONASS L10F, BeiDou B1 receiver

 High accuracy VCTXO oscillator disciplined to GNSS receiver

 Selectable IRIG-B or IRIG-G time code generator

 Amplitude modulated and DCLS timecode output

 1 PPS output

 Serial NMEA 0183 output, including GPS/UTC Time & Position

 UTC time synchronization

 IRIG timecode offset can be applied in term of HH:MM

 Adjustable output level for IRIG modulated signal

 Selectable PPS rising/falling edge

 Leap second determination based on GPS/GLONASS integration

 RS232 setup port for configuration


OEM solution, easily integrated in demanding systems

gle/GPS-IRIG-ENC-100-OEM is a flexible, compact, selectable IRIG B or G encoder in a small footprint board, with an embedded GNSS receiver.

Designed for easily OEM integration, it has multiple output interfaces: choice of 

AM modulated or baseband IRIG DCLS timecode signals, as well as 1 PPS digital output and NMEA0183 RS232 time and position information.
Control and data communication are supported by a RS232
Small form factor, low power consumption, and a widely available +5V power supply allow a
hassle-free OEM system integration.


Main characteristics

Modulated IRIG Format



1 kHz

100 kHz


Modulated IRIG Level

Adjustable from 2Vpp to 5Vpp (Mark), unloaded, in sixteen steps

Baseband DCLS IRIG Format



100 Hz

  10 kHz


Baseband DCLS IRIG Level

TTL (>3V @ 50 Ohm load)

IRIG Time Offset

Max ± 12 Hours in HH:MM format


Selectable between rising and falling edge

1 PPS Level

TTL (>3V @ 50 Ohm load)

NMEA 0183

RS232, 19200 Baud, 8 bit, no parity. $GNRMC,$GNVTG,$GNGGA,$GNGSA,$GPGSV,$GNGLL,$GNZDA

GPS Engine

Embedded 72 Channels GPS L1, GLONASS L10F and BeiDou B1 receiver

Timing Accuracy

+/-0.5 PPM (when not locked to GPS / over the entire temp. range)

Setup port

RS232, 9600 Baud, 8 bit, no parity

Power supply

+5V, 120mA

I/O connector

40 pin plug double row 1.27 mm pitch

Antenna connector

MMCX socket


PCB 65 x 40 x 7 mm excluding antenna and I/O connector


Most of the optional features and functions can also be added later on, directly in the field.
Contact the factory for all the details on the possible configurations.


This product is not intended for applications whose its failure to perform can be expected to cause damages to properties and/or persons and/or injury to human life.